Christmas Serviette ties and Candles

Print the holly leaf pattern from the photo.  The width between the bottom of the leaves should be approximately 3 3/4" wide.  Cut out the pattern and drawn round this onto green shiny card (if you don't have shiny card, any green thin card will do)  Cut out the holly and push a small hole in the centre of the leaves shown on the pattern.  You can make the markings of the leaves using an embossing tool or anything with a blunt point.  Cut approximately 1/2 metre of tying ribbon, but this can vary according to the item that you wish to tie your finished flower around.  Make up the flower as in the the 'brad flowers' instrcuction that comes with each mesh pack, but before opening the brad points to secure the mesh push the holly onto the brad through the hole right side down.  Push the points of the brad through the centre of the ribbon and then open the brad points outwards to secure everything in place.  Your Christmas flower is now ready to tie around your serviettes or project.